Pendant necklace making

A pendant is the enchanting accessory. Typically, a pendant can flatter your facial features, reflect your personality, and complement your wardrobe. Many fashion pendants are available at jewelry retailers. A bail is generally a metal loop at the top of the pendant through which a necklace is strung. bail enable you to connect a pendant to the necklace. The following are guideline of pendant connect the necklace.

String on one pearl (or turquoise,crystals) bead spacer onto a head pin. Repeat stringing beads onto head pins. You just need three different beaded head pins.

With the needle nose pliers grip the head pin just above the bead spacer.

Place your nose pliers at the point of the bend. Pull the wire around one side of the pliers to make a loop large enough.

Push the jewelry wire all the way through the hole in the pendant. Let 1/2 inch of wire emerge from the hole at the bottom of the pendant. Let more wire hang out of the bottom if your pendant has large holes.

Bend the two ends up until they cross. Using your needle nose pliers pinch the wires at the crossing point until the wires straighten.

Grip the two wires with the needle nose pliers so the top of the pliers is aligned with the top of the short wire. Bend the longer side to a 45 degree angle.

Add a jump rings to one end of your chain. Do this by twisting open the ring then sliping it on to the last link of one of the ends of the necklace. Close the ring back up.

Add another jump ring to the unfinished end of the chain, slip on our clasp and then close the jump ring tight.