How to make a bead and wire loop pendant

There are many kinds of pendants in the jewelry stores. However, it is not easy to choose the perfect one. If you alway pay attention to the fashion jewelry news in your daily life, you must know the increasing popularity of the loop pendant. Many people are fascinated by the beauty and attraction of this pendant. If you also want to get one, you can choose the special but exciting way, that is making it by yourself.
Step one- You should cut the wire about 10cm long and bend the wire about 3mm with the nose pliers.
Step two- Grip the wire when you have done the step one. Then, bend the wire around and turn it to the opposite side of the pliers to form the loop. The step is very important and easy.
Step three- Using the nose pilers grip the loop and then bend the long end in order to adjust it parallel with the short one.
Step four- Using the nose piler to take both the wires together and bend the long end carefully. Thread the beads with the wire according to the design you have determined in advance. You should determine what the pendant is for and which kinds of beads are your favorite. You should make a smaller pendant when you want to decorate the earrings with it.
Step five- Bend the wire to complete the loop and perfect the beads. You should wrap the wire insistently until all the straight section is covered. Cut off all the excessive wire and complete the pendant perfectly.
The loop pendant can be used to enhance the beauty of many kinds of jewelry pieces. The previous tips may be quite useful when you want to make a bead and wire loop pendant. You can get your charming jewelry just by your own hands.