How to add charms to bracelet wire

Often when creating charm bracelets of this type, you will string small and colorful beads on the bracelet wire. And you can gradually add to the bracelet by giving charms on special occasions. Now learning to add charms to bracelet wire from this article is a good idea.
Cut a 10-inch length of stringing wire. String one crimp bead onto one end of the wire. Look for a small silver ring attached to the charm and grip each side of the ring’s opening with a pair of pliers. Pull one side of the silver ring toward you with a pair of pliers and push the other side away at the same time. The ring should open when you do this, leaving a large gap. Pass the end of the wire through one-half of the closure clasp and then pass the end of the wire back through the crimp bead.
Determine your beading design on the bead board. Add your silver charm to the charm bracelet by sliding the opened ring around one of the bracelet's chain links. Space the charms evenly among the beads so you know where they need to go as you are stringing the beads.
Finish the bracelet by adding the second crimp bead and the other half of the closure clasp using the same method as described in step one. Clip the excess stringing wire to finish the bracelet. Tighten the silver ring by gripping each side with pliers and pushing the sides toward each other.