Floating crystal bracelet making introduction

Floating crystal jewelry is a common kind of bracelet, and it is anything in which the crystal in the jewelry is not visually connected to the rest of the piece. Following the steps in this article, you can make a simple floating crystal bracelet using a few pieces of crystal and some jewelry wire.
First step, measure around your wrist twice if an adult and three times if a child and then start by putting a clasp on one end
Second step, attach one part of your clasp to the end of your jewelry wire. Simply thread about 1 inch of the jewelry wire through the clasp, and use your needle nose pliers to twist the short end of the wire around the long end of the wire twice. Loop one end of the wire with pliers.
Third step cut off the small tail and place a crimp bead over the wound wire. Use your crimping pliers to secure the bead around the wound wire. This will make sure that your clasp is secure on the wire.
Fourth step Thread your beads in an alternating pattern on the wire. First thread a 3mm bead, then the 5mm bead, and then the last 3mm bead.
Fifth step now, add another crimp bead to the loose side of the beads. Make sure the crimp bead is flush up against the beads.
At last, you will tie on the other end of your clasp. Thread about ½ an inch of wire through the clasp. Use your needle nose pliers to twist the short end around the clasp twice.
Now, you have learnt how to make a floating crystal bracelet, start to work following there points above.